Lsm Services Deeside Ltd

Customer dropped off his old log splitter that required a bit of TLC
New push plate fabricated, new valve block complete with new hydraulic hoses fitted...
The log splitter was also raised to approximately 600mm to make it more ergonomically friendly for the operator

Forestry band tracks Overhauled.
As seen in the pictures, the C links were badly worn / defective, all the C links and forged links were removed and new components that were supplied by the customer installed

Heavy roller delivered with a serious water leak, the centre sleeve had split, old sleeve removed, and replaced with new sections this allowing the customer to roll his grass parks
Smiddys are essential - Supporting Farming - Supporting primary Industry

Front loader bucket, repaired, new faceplate, side plates and wear strips installed

Replacement crumbler bar fabricated and ready to collect

In addition to the pipe unroller posted yesterday, the customer sent me this video, with it’s working grand...

Water pipe unroller fabricated and painted, this was fabricated to accommodate rolls of 40mm alkathene pipe for under floor heating.

Adjustable brackets fabricated to accommodate pipes for a one pass seed drill

Replacement shed doors, Henderson 301 tracking and hanging Brackets fitted at Ledmaccoy, Strathdon last week, a big thank you to Ian Stuart for assisting me with fitting them 👍👍

Ritchie Calf creep required a replacement trough, customer also asked if I could give it a sand blast and a lick of new paint, which he supplied

Euro head stock, supplied & fitted to a skid steer Bob cat, to allow the customer to muck out his poly tunnels

50 x 25 box sections railings, fabricated, and fitted in cookney.... these were also galvanised and powder coated to ensure there is no maintenance required...

Digger Hitch fabricated with 65mm pins and grapple arms
This bolt on hitch was specifically designed to work on a mulcher
The customer Is to be working on steep ground, and required a solution in regards to assisting with pulling himself up with the digger jib when needed, which is not possible with the mulcher alone
... The grapple arms, fabricated with 100 x 25mm flat bar, were made to bolt on and off the hitch, so that the hitch could be utilised on other attachments if required
The grapple arms and 65mm pins were cranked / offset to allow the operator to fold the entire unit in, to allow the mulcher to be released from the digger
See More

Another fire grate fabricated today

4170mm long x 3050mm wide shed doors fabricated - sheeted with Slate blue box profile, now loaded and ready for delivery and installation at Strathdon

Cast Iron wheels that are to be used for a stationary engine trolly blasted & primed
Rims from a 35 fergie, blasted and primed
Rims from a lorry that were blasted a while ago finally primed.

Pair of slating irons fabricated